Making manifolds.

[deeks]

The Skid Factory has several educational vids on car customizing/rebuilding. It is interesting to find out that small businesses are still casting for small quantities and one-offs.
If you are a petrol head the youtube videos are worth a look at.

[Bettyboo]

Even in these times of extreme boredom and drastic searches for any content to fill time, this video is, errm, a non-starter. But I can match it!

[Bogon]

Would never watch anything so boring.

Up your hame Betty!

[Neverna]

As it's in the motoring section, I watched this yesterday. It could be a cheaper option than buying a new electric vehicle.



Same guy, different car.

[Bettyboo]

^ the first of the two is lovely.

^^ sorry, mate - point taken.

[jabir]

Even in these times of extreme boredom and drastic searches for any content to fill time, this video is, errm, a non-starter. But I can match it!

Another week in isolation and I might watch that, again.

[Coremouse]

Always cheaper to diy weld your own mani.
Stainless steampipe elbow cost <$0.7/piece shipped from China, and refill Argon here in Thailand is very cheap. (600baht for a 6m^3 cylinder, or equivalent of CF200). I welded my dual wastegates, fully backpurged header effectively for $60( reused old flange and collector )

[deeks]

Why is there an "aftermarket"? Because blokes like of him?

[deeks]

Example, this manifold is made by who?

[deeks]

^ Next to come is "This is dangerous to the environment" "You cant do That""For the sake of our children""It's damaging the the Ozone Layer"

[David48atTD]

As it's in the motoring section, I watched this yesterday. It could be a cheaper option than buying a new electric vehicle.

Really enjoyed watching that ...